lester107
11-26-2005, 03:10 PM
for any trigger that has a magnet you cant seem to get out here is what to do.
Materials:
1.small drill bit about a 9/16 maybe alittle bigger with drill
2.small nail about the size of the hole you drill with a hammer
Steps:
1. remove the trigger from the frame
2. place part that hits the switch where the magnet is magnet side down on edge of table
3. drill hole in it just until your right on the outside of the magnets metal shell
4. take nail, put it in the hole you drilled, then hit untill magnet pops out(if it doesnt come out try drilling the hole alittle deeper).
5. reasemble marker and go mow faces with new lighter non-magnetic pull
i am not responsable if you break your trigger, as for pictures i dont have any right now and im not sure if i will ever be ale to get any.
if anyone is interested ad cant do this themselves i am willing to do it for a small fee
Materials:
1.small drill bit about a 9/16 maybe alittle bigger with drill
2.small nail about the size of the hole you drill with a hammer
Steps:
1. remove the trigger from the frame
2. place part that hits the switch where the magnet is magnet side down on edge of table
3. drill hole in it just until your right on the outside of the magnets metal shell
4. take nail, put it in the hole you drilled, then hit untill magnet pops out(if it doesnt come out try drilling the hole alittle deeper).
5. reasemble marker and go mow faces with new lighter non-magnetic pull
i am not responsable if you break your trigger, as for pictures i dont have any right now and im not sure if i will ever be ale to get any.
if anyone is interested ad cant do this themselves i am willing to do it for a small fee